Skip to content
Circuits Playground
Menu

I2C Explained: SDA, SCL, Addresses and Pull-ups

Updated

How the two-wire I2C bus connects displays and sensors, why addresses matter, and the default pins on popular boards.

Two wires, many devices

I2C uses SDA (data) and SCL (clock) plus a shared ground. Several devices can share the same two wires because each one answers only to its own 7-bit address, such as 0x3C for most SSD1306 OLEDs or 0x27 for many LCD backpacks.

Default pins

  • Arduino Uno: SDA = A4, SCL = A5 (fixed).
  • ESP32 DevKit: SDA = GPIO21, SCL = GPIO22 by default; other output-capable pins can be used with Wire.begin(SDA, SCL).
  • ESP32-C3 Super Mini (Arduino core): SDA = GPIO8, SCL = GPIO9 by default.
  • Raspberry Pi Pico: I2C0 or I2C1 on specific pin pairs, e.g. GP4/GP5 for I2C0. SDA and SCL must belong to the same controller.

Pull-up resistors

I2C lines are open-drain: devices only pull them LOW, and resistors pull them HIGH. Most breakout boards already include pull-ups. If those pull-ups go to 5 V, the bus is at 5 V, which matters for 3.3 V boards.

Debugging checklist

  1. Run an I2C scanner sketch and confirm the address.
  2. Check SDA and SCL aren't swapped.
  3. Make sure the module shares ground with the board.
  4. If two devices report the same address, change one using its address jumper or pin.

Related