Electrical safety
Last updated 2026-11-12
Most projects on Circuits Playground use low-voltage DC (5 V or less) from USB or batteries. Even so, mistakes can damage parts, overheat batteries or start fires. Read this before you build.
Mains (AC) voltage
Mains electricity can kill. Projects that switch mains loads are marked with a prominent warning and require extra confirmation in the builder. Mains wiring should only be done by a qualified person, inside a closed, rated enclosure, with appropriate fusing and earthing.
Low-voltage rules
- Disconnect power before changing any wiring.
- Check every power and ground wire against the wiring table before powering up.
- Never connect a supply directly to ground. Never feed 5 V into a 3.3 V-only pin.
- Drive motors, pumps and solenoids through a relay, transistor/MOSFET or motor driver, never directly from a GPIO.
- Use lithium batteries only with proper protection circuits and chargers.
- If something gets hot, smells or smokes, disconnect power immediately.
What our checks can and cannot do
The automatic wiring checker finds known mistakes using rules and the component library. It is not a simulator and cannot prove that a circuit is safe or will work. Status labels show whether a project is AI-generated, rule-checked, reviewed by an editor or physically tested.