Development boards
NodeMCU ESP8266 (ESP-12E, v3)
Low-cost Wi-Fi board with an ESP8266, 3.3 V logic, one analog input and micro-USB power.
- Logic level
- 3.3 V (not 5 V tolerant)
- Manufacturer
- Espressif (SoC) / various (board)
- Reference
- Datasheet / documentation
- Catalogue ID
- nodemcu-esp8266 v1
Pinout
| Pin | Type | Details |
|---|---|---|
| A0 | GPIO | Analog in · Input only · No internal pull-up · Single analog input, 0–3.3 V on NodeMCU/D1 mini (on-board divider to the 1 V ADC). |
| EN | System / control | - |
| RST | System / control | - |
| GND | Ground | - |
| VIN | Power output | 5 V · max ~500 mA · USB 5 V when powered over USB. |
| 3V33V3B | Power output | 3.3 V · max ~300 mA |
| D0GPIO16 | GPIO | Digital I/O · GPIO16 has no PWM, interrupts or I2C; it is used to wake from deep sleep. |
| D1GPIO5 | GPIO | Digital I/O · PWM · Default SCL |
| D2GPIO4 | GPIO | Digital I/O · PWM · Default SDA |
| D3GPIO0 | GPIO | Digital I/O · PWM · Strapping pin |
| D4GPIO2 | GPIO | Digital I/O · PWM · Strapping pin · On-board LED |
| 3V3 | Power output | 3.3 V · max ~300 mA |
| GNDGND2 | Ground | - |
| D5GPIO14 | GPIO | Digital I/O · PWM · SPI SCK |
| D6GPIO12 | GPIO | Digital I/O · PWM · SPI MISO |
| D7GPIO13 | GPIO | Digital I/O · PWM · SPI MOSI |
| D8GPIO15 | GPIO | Digital I/O · PWM · Strapping pin · SPI SS |
| RXGPIO3 | GPIO | Digital I/O · PWM · UART0 RX |
| TXGPIO1 | GPIO | Digital I/O · PWM · UART0 TX |
Wiring notes
- Board labels (D1, D2…) differ from GPIO numbers: D1 = GPIO5, D2 = GPIO4.
- D3 (GPIO0), D4 (GPIO2) and D8 (GPIO15) affect boot; avoid pulling them the wrong way at power-on.
- SD0–SD3, CMD and CLK are connected to the flash chip and are not usable.
Safety
- GPIO pins are 3.3 V only and are not officially 5 V tolerant.